Since the sink is a sanitary device, which provides reception of used water and its direction to the drainage system, work on its installation is usually made after the installation of plumbing and drainage system.
Practice shows that to ensure the comfortable use of the sink, the height of its location from the floor should be approximately eighty-five centimeters, while, to carry out the fixing of this product at a height, a little less, there is no sense.
The same requirements apply to kitchen sinks. It is necessary to adhere to these regulations not only when buying and installing mounted models of sinks and sinks, but also those that are sold in the retail network in place with pedestals.
Before you start working on installing the sink, you should decide on the place of its mounting, based on the possibility of connecting a faucet or mixer, location of the drain hole, etc.д.
In principle, the connection points should already be determined when installing the piping and sewage systems, but there are different options. Once the location of the sink is determined, you need to choose how to mount it. Brackets, a pedestal, a pedestal, special shelves, etc., can be used for this purpose.п.
In the next step, provided there are no peculiarities, made measurements of the recommended height of the location of the sink from the floor, and at the recommended height is drawn, with a pencil or marker, the line. It will mark the upper edge of the product.
On its back side there is a plane of adjacency to the supporting surface. Measuring its width, the resulting value is postponed down the wall, counting from the first line. Pay attention to the fact that both lines were strictly horizontal.
After that, measure the distance between the holes for mounting brackets, located on the back plane of the sink. The resulting value is marked on the top line. To ensure symmetry, you can use the neck of the product drain as a reference point.
Then, step back from the top of the line to the height between the top edge and the center of the mounting hole, holes are made in the wall for dowels, and install the plugs in them.
Next, the attachment of brackets, on which the suspended sink will be installed, is made. Using special horn wrenches on the underside of the fixings of the product are tightened, and later, the installation of a faucet, siphon, and. т.д.
And if you want to continue to make repairs with your own hands, then you just need to visit the portal diy. On the portal you will find a lot of useful information, such as master class on installing laminate flooring, or self-installation of a suspended ceiling and much, much more.
