I would like to note right away that it is desirable to carry out the installation of a bathtub almost in the last turn. The fact is that by laying out the tile on the wall above the already installed bathroom, you risk dropping some tool or tile itself, which will inevitably cause damage to the enamel. It is better to lay a tile so that one empty row to the edge of the bath. The bath itself can be installed on the legs that are supplied in the kit, but it is not always convenient. The problem can be solved by installing a bath on bricks. To do this, it is enough to put two rows of bricks at a distance of 50-60 crops from each other, so that the height of the «fences» amounted to about 19-20 cm. Wash the height of the baths to the total height after installation turned out to be approximately 60 cm. The direction must be perpendicular to the longitudinal axis of the bath. Before installing, inspect the bottom of the bath, make sure that there are no irregularities on the installation places on bricks. Please note, if you are interested in making money at home, then by clicking on the above link, you will receive detailed information about this.
Between the bottom of the bath and the bricks, it is better to lay a layer of thin fabric-based insulation so that the bricks do not crumble, seal the installation sites with foam or adhesive. A little secret for steel bathtubs. To ensure that the water in the bath does not cool down for longer, and so that the water jet does not fall to the bottom of the bath with a roar, insulation or foam can be applied or glued to the entire surface of the bottom from the outside.
When installing a cast-iron bath, you don’t have to worry too much about stability and stability, it’s enough to seal the junction with the bricks with an adhesive.
A steel bath tends to slightly change its linear dimensions when heated and cooled due to the expansion and contraction of the metal, so you need to fix the corners closest to the long wall so that the gap between the bath and the wall does not gradually increase. The longitudinal junction of the edge of the bath to the wall should be as fixed as possible. The edges of the sides should be installed strictly horizontally, since the slope for the drain is provided in the very shape of the bottom of the bath.
Do not forget that the lungs and therefore unstable acrylic baths during installation are necessarily attached to the walls!
After installation, you will still lay out the last layer of the tile directly above the side of the bath, leaving a small gap, which after filling the foam, closing the water path under the bath.
